Once a gas leak has been found and the supply has been turned off, the immediate risk has been controlled. The next stage is to deal with the problem properly by identifying the exact source and carrying out a targeted repair.
The system is safe, but not yet resolved.
In most properties we attend, the leak can be traced to a specific point within the pipework, allowing it to be repaired without replacing the entire system.
Our Gas Leak Detection service focuses on tracing confirmed gas leaks after isolation, identifying the exact fault, and carrying out the correct repair so the system can be safely reinstated.
Confirming the Leak Location
Before any repair work begins, the exact location of the leak must be confirmed. Although the system has failed a test, this does not show where the gas is escaping from.
The location is still unknown.
We trace the pipework step by step to identify the precise point of failure. This ensures the repair is carried out in the correct place.
Without tracing, any repair decision is based on assumption rather than confirmed evidence.
Assessing the Condition of the Pipework
Once the leak is located, the affected section of pipework is assessed. In most cases, the issue is localised rather than widespread.
We assess the fault directly.
This allows us to determine whether a direct repair is suitable or whether further work is genuinely required.
Most gas leaks occur at a specific joint, fitting, or section of pipe rather than across the full system.
Carrying Out a Targeted Repair
Once the condition has been confirmed, the repair is carried out at the exact location of the fault. This may involve repairing or replacing a small section of pipework.
We repair the source of the leak.
This approach avoids unnecessary pipe replacement and limits disruption within the property.
In most cases, a targeted repair is sufficient once the leak has been accurately traced.
Retesting the System
After the repair is completed, the system is retested to confirm it is holding gas correctly and that no further leaks are present.
The system must pass testing before it can be used again.
This step ensures the repair has been successful and that the system is safe for reinstatement.
Verification is essential before the gas supply can be turned back on.
Reinstating the Gas Supply
Once the system has been repaired and passed all required tests, the gas supply can be reinstated safely.
The system is returned to service.
This ensures that appliances can be used again with confidence that the leak has been fully resolved.
Why Accurate Diagnosis Makes the Difference
Without accurate tracing, repairs often involve replacing pipework unnecessarily or carrying out disruptive work without confirming the source.
We diagnose before we repair.
By identifying the exact fault first, we keep the repair targeted, reduce disruption, and ensure the solution reflects the actual condition of the system.
Knowing where the leak is allows the problem to be resolved properly the first time.
What to Do Next
If your gas supply has been turned off due to a confirmed leak, the next step is to trace the exact source and carry out the correct repair before reinstating the system.
Our Gas Leak Detection service identifies confirmed gas leaks after isolation, locates the exact fault, and carries out targeted repairs so your system can be safely restored without unnecessary pipe replacement.
